Sublimation Skeleton face leopard - 16oz glass can wrap

This listing is for a 16oz Libby glass can wrap.
The dimensions of this wrap will be 9.598x3.43

PLEASE NOTE 

It is your responsibility to measure your can and make sure these measurements work for you, as some other glass cans may measure differently. If you need a different size, please contact me BEFORE adding any designs for this, to your cart, so I can add your size to the listings. 
I will ONLY print the size you order. 
Each design will come on a full sheet. You will need to cut them down to size to fit properly around your can. 

All of my sublimation transfers are done with a-sub paper and Printers Jack ink.
I have spent a lot of time, trial and error perfecting my print settings and supplies to give you the best prints possible with the most ink and vibrant colors!

If you are new to sublimation it’s important to know that these inks are activated by heat and prefer a high percent polyester to perform at their best.
Prints may look dull when you receive them, but once pressed you will see their true colors.
It’s recommended that you press these transfers onto 65% polyester or hIgher. The lower the percentage, the more of a dull vintage look you will get.

These ready to press transfers should be pressed for 60 seconds at 400 degrees with a heat press.
If you are using an oven, Cricut press or tumbler press, please refer to their instructions on recommended times and temps.

Please note that I do not own a white toner printer, so these designs are intended to be used on light colored items, or items that are bleached for a white background (such as bleached shirts) Any areas of the design that are white, will take on the color of what you press these transfers onto.

All designs will be printed on a 8.5"x11" Asub paper, but the design itself can be sized down to any size you would like.
Please refer to the size options available in the drop down menu. If you do not see the size you are looking for, please feel free to message me BEFORE ordering, as I will add any size you’d like.
Size options are in height and width, however, depending on the actual design, it may differ. All designs however, will always be done with the longest side as standard.

If you have a preference on a design being horizontal or vertical, please contact me or leave a note with your order, as some designs can go wither way.
If you do not leave a note, I will print them the way I feel looks best.

If you are buying these transfer prints for tumblers, please keep in mind that I am not currently offering tapered prints. These will need to be used for straight tumblers.
Again, if you do not see a size you need, please message me before ordering, so I can add the size to the listings for you to order with.